TMPM361F10FG Toshiba, TMPM361F10FG Datasheet - Page 548

• Manufacturer Part Number: TMPM361F10FG
• Manufacturer: Toshiba

Specifications of TMPM361F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Contact Us
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 100
• Package: LQFP(14Ã?14)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 3
• Uart/sio (ch): 5
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: 8
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

18.4
Key-on Wakeup Operation
18.4
CG to determine whether to use the key inputs for releasing the STOP mode or for normal interrupts. Setting <IN-
TLEN> to "1" causes all the key inputs, KEY0 to KEY3, to be used for interrupts for releasing the STOP mode.
KWUPCRn<KEYn> to define the active state of each key input pin to be used.
CGIMCGF in the CG as the active high level. Therefore, program CGIMCGF<EMCGL[2:0]> to "001" to deter-
mine the detection level to the high level.
rupts. In this case, to be detected interrupt request by the CPU, "High" pulse or "High" level signal must be input.
"1010" to KWUPCLR<KEYCLR[3:0]> during interrupt processing clears all the key interrupt requests.
TMPM361F10FG has 4 key input pins, KEY0 to KEY3. Program the CGIMCGF<INTLEN> register in the
Program KWUPCRn<KEYnEN> to enable or disable interrupt inputs for each key input pin. Also, program
Detection of key inputs is carried out in the KWUP block, and the detection results are notified to the
Setting CGINCGF<INTLEN> to "0" (default) configures all the input pins, KEY0 to KEY3 to the normal inter-
Program KWUPCRn in the same way to enable or disable each key input and define their active states. Writing
Note:If two or more key inputs are generated, all the key input requests will be cleared by clearing interrupt requests.
Key-on Wakeup Operation
Page 524
TMPM361F10FG