TMPM361F10FG Toshiba, TMPM361F10FG Datasheet - Page 632

• Manufacturer Part Number: TMPM361F10FG
• Manufacturer: Toshiba

Specifications of TMPM361F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Contact Us
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 100
• Package: LQFP(14Ã?14)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 3
• Uart/sio (ch): 5
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: 8
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

22.2
Operation Mode
Table 22-9 Transfer Format for the Chip and Protection Bit Erase Command
Boot
ROM
22.2.9.4
1 byte
2 byte
3 byte
4 byte
5 byte
6 byte
7 byte
8 byte
Note 1: In I/O Interface mode, the baud rate for the transfers of the first and second byte must be 1/16 of the
Note 2: In case of any negative acknowledge, the boot program returns to a state in which it waits for a com-
Byte
Chip Erase and Protect Bit Erase
desired baud rate.
mand code (3rd byte). In I/O Interface mode, if a communication error occurs, a negative acknowl-
edge does not occur.
Serial operation mode and baud rate
For UART mode : 0x86
For I/O Interface mode : 0x30
−
Command code (0x40)
−
Chip erase command code (0x54)
−
−
(Wait for the next command code.)
Data Transferred from the Controller to the
TMPM361F10FG
Page 608
Desired baud
rate (Note 1)
Baud rate
−
ACK for the serial operation mode byte
・For UART mode
- Normal acknowledge : 0x86
(The boot program aborts if the baud rate can
not be set correctly.)
・For I/O Interface mode
- Normal acknowledge :0x30
−
ACK for the command code byte (Note 2)
- Normal acknowledge : 0x10
- Negative acknowledge : 0xX1
- Communication error : 0xX8
−
ACK for the command code byte (Note 2)
- Normal acknowledge : 0x10
- Negative acknowledge : 0xX1
- Communication error : 0xX8
ACK for the chip erase command code byte
- Normal acknowledge : 0x4F
- Negative acknowledge : 0x4C
−
Data Transferred from the TMPM361F10FG to
the Controller
TMPM361F10FG