DF2148BTE20 Renesas Electronics America, DF2148BTE20 Datasheet - Page 219

• Manufacturer Part Number: DF2148BTE20
• Description: IC H8S MCU FLASH 128K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2148BTE20

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: I²C, IrDA, SCI, X-Bus
• Peripherals: PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2148BTE20; HD64F2148BTE20

7.6
7.6.1
The procedure for using the DTC with interrupt activation is as follows:
1. Set the MRA, MRB, SAR, DAR, CRA, and CRB register information in on-chip RAM.
2. Set the start address of the register information in the DTC vector address.
3. Set the corresponding bit in DTCER to 1.
4. Set the enable bits for the interrupt sources to be used as the activation sources to 1. The DTC
5. After one data transfer has been completed, or after the specified number of data transfers have
7.6.2
The procedure for using the DTC with software activation is as follows:
1. Set the MRA, MRB, SAR, DAR, CRA, and CRB register information in on-chip RAM.
2. Set the start address of the register information in the DTC vector address.
3. Check that the SWDTE bit is 0.
4. Write 1 to the SWDTE bit and the vector number to DTVECR.
5. Check the vector number written to DTVECR.
6. After one data transfer has been completed, if the DISEL bit is 0 and a CPU interrupt is not
is activated when an interrupt used as an activation source is generated.
been completed, the DTCE bit is cleared to 0 and a CPU interrupt is requested. If the DTC is to
continue transferring data, set the DTCE bit to 1.
requested, the SWDTE bit is cleared to 0. If the DTC is to continue transferring data, set the
SWDTE bit to 1. When the DISEL bit is 1 or after the specified number of data transfers have
been completed, the SWDTE bit is held at 1 and a CPU interrupt is requested.
Procedures for Using DTC
Activation by Interrupt
Activation by Software
Section 7 Data Transfer Controller (DTC)
Rev. 3.00 Mar 21, 2006 page 163 of 788
REJ09B0300-0300