TMPM330FWFG Toshiba, TMPM330FWFG Datasheet - Page 107

• Manufacturer Part Number: TMPM330FWFG
• Description: Microcontrollers (MCU) MCU w/ ARM Cortex-M3 128K FLASH, 8K SRAM
• Manufacturer: Toshiba

Specifications of TMPM330FWFG

• Processor Series: TX03
• Core: ARM Cortex M3
• 3rd Party Development Tools: MDK-ARM, RL-ARM, ULINK2
• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 128K
• Rom Type: Flash
• Ram (kbytes): 8K
• Number Of Pins: 100
• Package: LQFP(14×14)
• Vcc: 3V
• Cpu Mhz: 40
• Ssp (ch) Spi: -
• I2c/sio (ch): 3
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: -
• Cs/wait Controller (ch): -
• Dma Controller: -
• 10-bit Da Converter: -
• 10-bit Ad Converter: 12
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 10
• Motor / Igbt Control: -
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit
• Lead Free Status / Rohs Status: Details

<bit0>
<bit1>
<bit3>
<bit7>
<bit8>
<bit10>
<bit11>
<bit12>
<bit13>
<bit14>
<bit15>
<bit16>
<bit17>
<bit18>
(Note) You must clear or set the active bits with extreme caution because clearing and setting
<MEMFAULTACT>
<BUSFAULTACT>
<USGFALTACT>
<SVCALLACT>
<MONITORACT>
<PENDSVACT>
<SYSTICKACT>
<USGFAULTPENDED>
<MEMFAULTPENDED>
<BUSFAULTPENDED>
<SVCALLPENDED>
<MEMFAULTENA>
<BUSFAULTENA>
<USGFAULTENA>
these bits does not repair stack contents.
Reads as “1” if Memory Management is active.
Reads as “1” if Bus Fault is active.
Reads as “1” if Usage Fault is active.
Reads as “1” if SVCall is active.
Reads as “1” if Debug Monitor is active.
Reads as “1” if PendSV is active.
Reads as “1” if SysTick is active.
Reads as “1” if Usage Fault is pended.
Reads as “1” if Memory Management is pended.
Reads as “1” if Bus Fault is pended.
Reads as “1” if SVCall is pended.
Set to “0” to disable or “1” to enable Memory Management.
Set to “0” to disable or “1” to enable Bus Fault.
Set to “0” to disable or “1” to enable Usage Fault.
Under development
Page95
TMPM330