D6417729RHF200BV Renesas Electronics America, D6417729RHF200BV Datasheet - Page 174

• Manufacturer Part Number: D6417729RHF200BV
• Description: IC SUPER H MPU ROMLESS 208QFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of D6417729RHF200BV

• Core Processor: SH-3 DSP
• Core Size: 32-Bit
• Speed: 200MHz
• Connectivity: EBI/EMI, FIFO, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, WDT
• Number Of I /o: 96
• Program Memory Type: ROMless
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 1.85 V ~ 2.15 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 208-QFP Exposed Pad, 208-eQFP, 208-HQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

Notes: 1. Priorities are indicated from high to low, 1 being the highest and 4 the lowest.
4.2.3
Processor resets and interrupts are asynchronous events unrelated to the instruction stream. All
exception events are prioritized to establish an acceptance order whenever two or more exception
events occur simultaneously.
All general exception events occur in a relative order in the execution sequence of an instruction
(i.e. execution order), but are handled at priority level 2 in instruction-stream order (i.e. program
order), where an exception detected in a preceding instruction is accepted prior to an exception
detected in a subsequent instruction.
Three general exception events (reserved instruction code exception, unconditional trap, and slot
illegal instruction exception) are detected in the decode stage (ID stage) of different instructions
and are mutually exclusive events in the instruction pipeline. They have the same execution
priority. Figure 4.2 shows the order of general exception acceptance.
Rev. 5.0, 09/03, page 126 of 806
2. The user defines the break point traps. 1 is a break point before instruction execution
3. Use software to specify relative priorities of external hardware interrupts and peripheral
4. See section 4.5.2, General Exceptions, for details.
Acceptance of Exceptions
and 11 is a break point after instruction execution. For an operand break point, use 11.
module interrupts (see section 7, Interrupt Controller (INTC)).