AT91SAM9G45-EKES Atmel, AT91SAM9G45-EKES Datasheet - Page 221

• Manufacturer Part Number: AT91SAM9G45-EKES
• Description: KIT EVAL FOR AT91SAM9G45
• Manufacturer: Atmel
• Series: AT91SAM Smart ARMr
• Type: MCUr

Specifications of AT91SAM9G45-EKES

• Contents: Board
• Processor To Be Evaluated: SAM9G45
• Data Bus Width: 32 bit
• Interface Type: I2C, SPI, UART
• Maximum Operating Temperature: + 50 C
• Minimum Operating Temperature: - 10 C
• Operating Supply Voltage: 1.8 V to 3.3 V
• For Use With/related Products: AT91SAM9G45
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q4626953

21.14 Programmable IO Delays
Figure 21-36. Programmable IO Delays
6438F–ATARM–21-Jun-10
SMC
The external bus interface consists of a data bus, an address bus and control signals. The simul-
taneous switching outputs on these busses may lead to a peak of current in the internal and
external power supply lines.
In order to reduce the peak of current in such cases, additional propagation delays can be
adjusted independently for pad buffers by means of configuration registers, SMC_DELAY1-8.
The additional programmable delays for each IO range from 0 to
delay can differ between IOs supporting this feature. Delay can be modified per programming for
each IO. The minimal additional delay that can be programmed on a PAD suppporting this fea-
ture is 1/16 of the maximum programmable delay.
When programming 0x0 in fields “Delay1 to Delay 8”, no delay is added (reset value) and the
propagation delay of the pad buffers is the inherent delay of the pad buffer. When programming
0xF in field “Delay1” the propagation delay of the corresponding pad is maximal.
SMC_DELAY1, SMC_DELAY2 allow to configure delay on D[15:0], SMC_DELAY1[3:0] corre-
sponds to D[0] and SMC_DELAY2[3:0] corresponds to D[8].
SMC_DELAY3, SMC_DELAY4 allow to configure delay on D[31:16], SMC_DELAY3[3:0] corre-
sponds to D[16] and SMC_DELAY4[3:0] corresponds to D[24]. In case of multiplexing through
the PIO controller, refer to the alternate function of D[31:16].
SMC_DELAY5, 6, 7 and 8 allow to configure delay on A[25:0], SMC_DELAY5[3:0] corresponds
to A[0]. In case of multiplexing through the PIO controller, refer to the alternate function of
A[25:0].
DELAY1
DELAYx
DELAYy
DELAY2
D_out[0]
D_out[1]
D_out[n]
D_in[0]
D_in[1]
D_in[n]
A[m]
PIO
PIO
Programmable Delay Line
Programmable Delay Line
Programmable Delay Line
Programmable Delay Line
4
AT91SAM9G45
ns (Worst Case PVT). The
D[0]
D[1]
D[n]
A[m]
221