TMP92CF26AXBG Toshiba, TMP92CF26AXBG Datasheet - Page 411

• Manufacturer Part Number: TMP92CF26AXBG
• Description: Microcontrollers (MCU) TLCS-900/H1 ROMLESS 144KB RAM
• Manufacturer: Toshiba

Specifications of TMP92CF26AXBG

• Processor Series: TLCS-900
• Core: 900/H
• Data Bus Width: 16 bit
• Program Memory Type: ROM
• Program Memory Size: 8 KB
• Data Ram Size: 144 KB
• Interface Type: I2C, I2S, UART, USB
• Maximum Clock Frequency: 80 MHz
• Number Of Programmable I/os: 136
• Number Of Timers: 10
• Maximum Operating Temperature: + 50 C
• Mounting Style: SMD/SMT
• Package / Case: FBGA-228
• Development Tools By Supplier: BM1040R0A, BM1055R0B, SW96CN0-ZCC, SW00MN0-ZCC
• Minimum Operating Temperature: 0 C
• On-chip Adc: 10 bit, 6 Channel
• Lead Free Status / Rohs Status: Details

USBREADY
(07E6H)
VDD
INTXX
PortXX
(Pull-up on/off)
Write signal
bit Symbol
Read/Write
Reset State
3.16.3.27 USBREADY Register
USBREADY (Bit0)
Note1: External pull-up resistor and control switch are needed with the TMP92CF26A.
Note2: The above setting is an example for when communication. A specific circuit is required to prevent cullent flow
0: Writing to descriptor RAM has finished.
1: Writing to descriptor RAM is enabled.
(However, writing to descriptor RAM is prohibited when connected to host.)
at connector detection , no-use, and no connection.
case, UDC disable detecting USB_RESET signal until USBREADY register is written
“0” after release of USB_RESET.
resistor is connected to host in OFF condition, this condition is equivalent condition
with USB_RESET signal by pull-down resistor on the host side. Therefore UDC is not
detected in USB_RESET until “0” is written to USBREADY register
This register informs finishing writing data to descriptor RAM on UDC.
After assigned data to descriptor RAM, write “0” to bit0.
Detect level of VDD signal from USB cable, and execute initialize sequence. In this
If the pull-up resistor on D+ signal is controlled by control signal, when pull-up
7
USB host
GND
6
15 kΩ
15 kΩ
92CF26A-410
5
Descriptor RAM access
Device ID RAM
Register in USB
R1 = 1.5 kΩ
4
R2
R3
3
VCC
VSS
PortXX
D+
D−
USBREADY registera access
2
TMP92CF26A
CPU
UDC
TMP92CF26A
1
2007-11-21
USBREADY
R/W
0
0