HD6417706 RENESAS [Renesas Technology Corp], HD6417706 Datasheet - Page 408

• Manufacturer Part Number: HD6417706
• Description: Renesas 32-Bit RISC Microcomputer Super RISC engine Family/SH7700 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Rev. 4.00, 03/04, page 362 of 660
Bit
3
2
Bit Name
PER
TEND
Initial Value
0
1
R/W
R/(W)* Parity Error
R
Description
Indicates that data reception (with parity) aborted
due to a parity error in the asynchronous mode.
0: Receiving is in progress or has ended normally
1: A receive parity error occurred
Transmit End
Indicates that when the last bit of a serial character
was transmitted, the SCTDR did not contain valid
data, so transmission has ended. TEND is a read-
only bit and cannot be written.
[Clearing condition]
TDRE is read as 1, then written to with 0.
[Setting conditions]
1. The chip is reset or enters standby mode.
2. TE bit in SCSCR is 0.
3. TDRE is 1 when the last bit of a one-byte serial
[Clearing conditions]
1. The chip is reset or enters standby mode.
2. PER is read as 1, then written to with 0.
Note: Clearing the RE bit to 0 in the SCSCR
[Setting condition]
The number of 1s in receive data, including the
parity bit, does not match the even or odd parity
setting of the parity mode bit (O/E) in SCSMR.
When a parity error occurs, the SCI transfers
the receive data into the SCRDR but does not
set RDRF. Serial receiving cannot continue
while PER is set to 1. In the clock synchronous
mode, serial transmitting also cannot continue.
character is transmitted.
does not affect the PER bit, which retains
its previous value.