HD6417706 RENESAS [Renesas Technology Corp], HD6417706 Datasheet - Page 444

• Manufacturer Part Number: HD6417706
• Description: Renesas 32-Bit RISC Microcomputer Super RISC engine Family/SH7700 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

TEND Flag and TE Bit Processing: The TEND flag is set to 1 during transmission of the stop bit
of the last data. Consequently, if the TE bit is cleared to 0 immediately after setting of the TEND
flag has been confirmed, the stop bit will be in the process of transmission and will not be
transmitted normally. Therefore, the TE bit should not be cleared to 0 for at least 0.5 serial clock
cycles (or 1.5 cycles if two stop bits are used) after setting of the TEND flag setting is confirmed.
Receive Error Flags and Transmitter Operation (Clock Synchronous Mode Only): When a
receive error flag (ORER, PER, or FER) is set to 1, the SCI will not start transmitting even if
TDRE is set to 1. Be sure to clear the receive error flags to 0 before starting to transmit. Note that
clearing RE to 0 does not clear the receive error flags.
Receive Data Sampling Timing and Receive Margin in the Asynchronous Mode: In the
asynchronous mode, the SCI operates on a base clock of 16 times the transfer rate frequency. In
receiving, the SCI synchronizes internally with the falling edge of the start bit, which it samples on
the base clock. Receive data is latched on the rising edge of the eighth base clock pulse (figure
14.24).
Rev. 4.00, 03/04, page 398 of 660
data (RxD0)
Synchro-
sampling
sampling
Receive
nization
timing
timing
Basic
clock
Data
Figure 14.24 Receive Data Sampling Timing in Asynchronous Mode
0 1 2 3 4 5 6 7 8 9 10111213 1415 0 1 2 3 4 5 6 7 8 9 10111213 1415 0 1 2 3 4 5
8 clocks
Start bit
16 clocks
–7.5 clocks
+7.5 clocks
D0
D1