HD64F3029XBL25V Renesas Electronics America, HD64F3029XBL25V Datasheet - Page 634

• Manufacturer Part Number: HD64F3029XBL25V
• Description: MCU 5V 512K,PB-FREE 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD64F3029XBL25V

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Bit 5-Programming Execution Error Detect (EE): 1 is returned to this bit when the specified
data could not be written because the user MAT was not erased or when flash-memory related
register settings are partially changed on returning from the user branch processing.
If this bit is set to 1, there is a high possibility that the user MAT is partially rewritten. In this case,
after removing the error factor, erase the user MAT.
If FMATS is set to H'AA and the user boot MAT is selected, an error occurs when programming
is performed. In this case, both the user MAT and user boot MAT are not rewritten.
Programming of the user boot MAT should be performed in the boot mode or PROM mode.
Bit 5
EE
0
1
Bit 4—Flash Key Register Error Detect (FK): Returns the check result of the value of FKEY
before the start of the programming processing.
Bit 4
FK
0
1
Bit 3—Unused: Returns 0.
Bit 2—Write Data Address Detect (WD): When flash memory area is specified as the start
address of the storage destination of the program data, an error occurs.
Bit 2
WD
0
1
Bit 1—Write Address Error Detect (WA): When the following area is specified as the start
address of the programming destination, an error occurs.
1. If the start address is outside the flash memory area
2. If the specified address is not a 128-byte boundary (A6 to A0 are not 0)
Description
Programming has ended normally
Programming has ended abnormally (programming result is not guaranteed)
Description
FKEY setting is normal (FKEY = H'5A)
FKEY setting is error (FKEY = value other than H'5A)
Description
Setting of write data address is normal
Setting of write data address is abnormal
Rev. 2.0, 06/04, page 605 of 980