HD6417320 RENESAS [Renesas Technology Corp], HD6417320 Datasheet - Page 408

• Manufacturer Part Number: HD6417320
• Description: Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7700 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 9
Bus State Controller (BSC)
9.5.5
SDRAM Interface
(1)
SDRAM Direct Connection
The SDRAM that can be connected to this LSI is a product that has 11/12/13 bits of row address,
8/9/10 bits of column address, 4 or less banks, and uses the A10 pin for setting precharge mode in
read and write command cycles.
The control signals for direct connection of SDRAM are RAS, CAS, RD/WR, DQMUU,
DQMUL, DQMLU, DQMLL, CKE, CS2, and CS3. All the signals other than CS2 and CS3 are
common to all areas, and signals other than CKE are valid when CS2 or CS3 is asserted. SDRAM
can be connected to up to 2 spaces. The data bus width of the area that is connected to SDRAM
can be set to 32 or 16 bits.
Burst read/single write (burst length 1) and burst read/burst write (burst length 1) are supported as
the SDRAM operating mode.
Commands for SDRAM can be specified by RAS, CAS, RD/WR, and specific address signals.
These commands are shown below.
• NOP
• Auto-refresh (REF)
• Self-refresh (SELF)
• All banks precharge (PALL)
• Specified bank precharge (PRE)
• Bank active (ACTV)
• Read (READ)
• Read with precharge (READA)
• Write (WRIT)
• Write with precharge (WRITA)
• Write mode register (MRS)
The byte to be accessed is specified by DQMUU, DQMUL, DQMLU, and DQMLL. Reading or
writing is performed for a byte whose corresponding DQMxx is low. For details on the
relationship between DQMxx and the byte to be accessed, refer to section 9.5.1, Endian/Access
Size and Data Alignment.
Rev. 3.00 Jan. 18, 2008 Page 346 of 1458
REJ09B0033-0300