UPD78F0537DGA(T)-9EV-A NEC, UPD78F0537DGA(T)-9EV-A Datasheet - Page 290

no-image

UPD78F0537DGA(T)-9EV-A

Manufacturer Part Number
UPD78F0537DGA(T)-9EV-A
Description
8BIT MCU, 128K FLASH, 7KB RAM, SMD
Manufacturer
NEC
Datasheet

Specifications of UPD78F0537DGA(T)-9EV-A

Controller Family/series
UPD78
No. Of I/o's
55
Ram Memory Size
7KB
Cpu Speed
20MHz
No. Of Timers
8
No. Of Pwm
RoHS Compliant
Core Size
8bit
Program Memory Size
128KB
Oscillator Type
External, Internal
290
<10> By performing the procedures above, an arbitrary carrier clock is obtained. To stop the count operation,
clear TMHE1 to 0.
If the setting value of the CMP01 register is N, the setting value of the CMP11 register is M, and the count
clock frequency is f
• Carrier clock output cycle = (N + M + 2)/f
• Duty = High-level width/carrier clock output width = (M + 1)/(N + M + 2)
Cautions 1. Be sure to set the CMP11 register when starting the timer count operation (TMHE1 = 1)
Remarks 1. For the setting of the output pin, see 9.3 (3) Port mode register 1 (PM1).
2. For how to enable the INTTMH1 signal interrupt, see CHAPTER 19
2. Set so that the count clock frequency of TMH1 becomes more than 6 times the count
3. Set the values of the CMP01 and CMP11 registers in a range of 01H to FFH.
4. The set value of the CMP11 register can be changed while the timer counter is
5. Be sure to set the RMC1 bit before the count operation is started.
FUNCTIONS.
after the timer count operation was stopped (TMHE1 = 0) (be sure to set again even if
setting the same value to the CMP11 register).
clock frequency of TM51.
operating. However, it takes the duration of three operating clocks (signal selected by
the CKS12 to CKS10 bits of the TMHMD1 register) since the value of the CMP11
register has been changed until the value is transferred to the register.
CNT
, the carrier clock output cycle and duty are as follows.
CHAPTER 9 8-BIT TIMERS H0 AND H1
User’s Manual U17260EJ6V0UD
CNT
INTERRUPT

Related parts for UPD78F0537DGA(T)-9EV-A