UPD78F0537DGA(T)-9EV-A NEC, UPD78F0537DGA(T)-9EV-A Datasheet - Page 69

• Manufacturer Part Number: UPD78F0537DGA(T)-9EV-A
• Description: 8BIT MCU, 128K FLASH, 7KB RAM, SMD
• Manufacturer: NEC

Specifications of UPD78F0537DGA(T)-9EV-A

• Controller Family/series: UPD78
• No. Of I/o's: 55
• Ram Memory Size: 7KB
• Cpu Speed: 20MHz
• No. Of Timers: 8
• No. Of Pwm: RoHS Compliant
• Core Size: 8bit
• Program Memory Size: 128KB
• Oscillator Type: External, Internal

3.2 Processor Registers
3.2.1 Control registers
program counter (PC), a program status word (PSW) and a stack pointer (SP).
(1) Program counter (PC)
(2) Program status word (PSW)
The 78K0/KE2 products incorporate the following processor registers.
The control registers control the program sequence, statuses and stack memory. The control registers consist of a
The program counter is a 16-bit register that holds the address information of the next program to be executed.
In normal operation, PC is automatically incremented according to the number of bytes of the instruction to be
fetched. When a branch instruction is executed, immediate data and register contents are set.
Reset signal generation sets the reset vector table values at addresses 0000H and 0001H to the program counter.
The program status word is an 8-bit register consisting of various flags set/reset by instruction execution.
Program status word contents are stored in the stack area upon interrupt request generation or PUSH PSW
instruction execution and are restored upon execution of the RETB, RETI and POP PSW instructions.
Reset signal generation sets PSW to 02H.
(a) Interrupt enable flag (IE)
This flag controls the interrupt request acknowledge operations of the CPU.
When 0, the IE flag is set to the interrupt disabled (DI) state, and all maskable interrupt requests are disabled.
When 1, the IE flag is set to the interrupt enabled (EI) state and interrupt request acknowledgement is
controlled with an in-service priority flag (ISP), an interrupt mask flag for various interrupt sources, and a
priority specification flag.
The IE flag is reset (0) upon DI instruction execution or interrupt acknowledgement and is set (1) upon EI
instruction execution.
PC PC15 PC14 PC13 PC12 PC11 PC10 PC9 PC8 PC7 PC6 PC5 PC4 PC3 PC2 PC1 PC0
15
PSW
Figure 3-17. Format of Program Status Word
IE
7
Figure 3-16. Format of Program Counter
CHAPTER 3 CPU ARCHITECTURE
Z
User’s Manual U17260EJ6V0UD
RBS1
AC
RBS0
0
ISP
CY
0
0
69