EP3SE50F780I3N Altera, EP3SE50F780I3N Datasheet - Page 426

• Manufacturer Part Number: EP3SE50F780I3N
• Description: Stratix III
• Manufacturer: Altera

Introduction
12–4
Stratix III Device Handbook, Volume 1
1
Enabling Remote Update
You can enable remote update for Stratix III devices in the Quartus II
software before design compilation (in the Compiler Settings menu). To
enable remote update in the project’s compiler settings, perform the
following steps in the Quartus II software:
1.
2.
3.
4.
5.
6.
7.
On the Assignment menu, click Device. The Settings dialog box
appears.
Click Device and Pin Options. The Device and Pin Options dialog
box appears.
Click the Configuration tab.
From the Configuration scheme list, select Active Serial (can use
Configuration Device)
From the Configuration Mode list, select Remote.
Click OK.
In the Setting dialog box, click OK.
When using the Fast AS mode, you need to select the Remote
Update mode in Quartus
altremote_update megafunction to access the circuitry. Refer to
“altremote_update Megafunction” on page 12–15
information.
(Figure
®
12–3).
II software and insert the
Altera Corporation
(Figure
for more
October 2007
12–3).