HD6417660 RENESAS [Renesas Technology Corp], HD6417660 Datasheet - Page 134

• Manufacturer Part Number: HD6417660
• Description: Renesas 32-Bit RISC Microcomputer
• Manufacturer: RENESAS [Renesas Technology Corp]

3.4
In DSP mode, data transfer instructions are added for the DSP unit registers. The newly added
instructions are classified into the following three groups.
1. Double data transfer instructions
2. Single data transfer instructions
3. System control instructions
In any DSP data transfer instructions, an address to be accessed is generated and output by the
CPU. For DSP data transfer instructions, some of the CPU general registers are used for address
generation and specific addressing modes are used.
Rev. 1.00, 02/04, page 96 of 804
The DSP unit is connected to the X memory and Y memory via the specific buses called X bus
and Y bus. By using the data transfer instructions using the X and Y buses, two data items can
be transferred between the DSP unit and X/Y memories simultaneously. These instructions are
called double data transfer instructions. These double data transfer instructions can be
described in combination with the DSP operation instructions to execute data transfer and data
operation in parallel.
The DSP unit is also connected to the L bus that is used by the CPU. The DSP registers other
than the DSR can access any virtual addresses generated by the CPU. In this case, the single
data transfer instructions are used. The single data transfer instructions cannot be used in
combination with the DSP operation instructions and can access only one data item at a time.
Some of the DSP unit registers are handled as the CPU system registers. To control these
system registers, the system control registers are supported. The DSP registers are connected
to the CPU general registers via the data transfer bus (C bus).
DSP Data Transfer Instructions