HD6417660 RENESAS [Renesas Technology Corp], HD6417660 Datasheet - Page 711

• Manufacturer Part Number: HD6417660
• Description: Renesas 32-Bit RISC Microcomputer
• Manufacturer: RENESAS [Renesas Technology Corp]

5. If the I bus is set for a break of an instruction fetch cycle, the condition is determined for the
25.3.3
1. If the L bus is specified as a break condition for data access break, condition comparison is
2. The relationship between the data access cycle address and the comparison condition for each
Table 25.3 Data Access Cycle Addresses and Operand Size Comparison Conditions
3. When the data value is included in the break conditions on channel B:
Access Size
Longword
Word
Byte
instruction fetch cycles on the I bus. For details, see 5 in section 25.3.1, Flow of the User
Break Operation.
performed for the logical addresses (and data) accessed by the executed instructions, and a
break occurs if the condition is satisfied. If the I bus is specified as a break condition, condition
comparison is performed for the physical addresses (and data) of the data access cycles that are
issued on the I bus by all bus masters including the CPU, and a break occurs if the condition is
satisfied. For details on the CPU bus cycles issued on the I bus, see 5 in section 25.3.1, Flow of
the User Break Operation.
operand size is listed in table 25.3.
This means that when address H'00001003 is set in the break address register (BARA or
BARB), for example, the bus cycle in which the break condition is satisfied is as follows
(where other conditions are met).
Longword access at H'00001000
Word access at H'00001002
Byte access at H'00001003
When the data value is included in the break conditions, either longword, word, or byte is
specified as the operand size of the break bus cycle register B (BBRB). When data values are
included in break conditions, a break is generated when the address conditions and data
conditions both match. To specify byte data for this case, set the same data in two bytes at bits
15 to 8 and bits 7 to 0 of the break data register B (BDRB) and break data mask register B
(BDMRB). When word or byte is set, bits 31 to 16 of BDRB and BDMRB are ignored. Set the
word data in bits 31 to 16 in BDRB and BDMRB when including the value of the data bus as a
break condition for the MOVS.W @-As,Ds, MOVS.W @As,Ds, MOVS.W @As+,Ds, or
MOVS.W @As+Ix,Ds instruction (bits 15 to 0 are ignored).
Break on Data Access Cycle
Address Compared
Compares break address register bits 31 to 2 to address bus bits 31 to 2
Compares break address register bits 31 to 1 to address bus bits 31 to 1
Compares break address register bits 31 to 0 to address bus bits 31 to 0
Rev. 1.00, 02/04, page 673 of 804