R4F24278NVFQU Renesas Electronics America, R4F24278NVFQU Datasheet - Page 454

• Manufacturer Part Number: R4F24278NVFQU
• Description: MCU 512K/48K 2.7-5.5V 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2400r

Specifications of R4F24278NVFQU

• Core Processor: H8S/2600
• Core Size: 16/32-Bit
• Speed: 33MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, Smart Card, SPI, SSU, UART/USART
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 98
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Eeprom Size: -
• Ram Size: 64K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Section 8 DMA Controller (DMAC)
• If a DMAC transfer cycle occurs immediately after a DMAC register read cycle, the DMAC
(2)
When the MSTP13 bit in MSTPCRH is set to 1, the DMAC clock stops, and the module stop state
is entered. However, 1 cannot be written to the MSTP13 bit if any of the DMAC channels is
enabled. This setting should therefore be made when DMAC operation is stopped.
When the DMAC clock stops, DMAC register accesses can no longer be made. Since the
following DMAC register settings are valid even in the module stop state, they should be
invalidated, if necessary, before a module stop.
• Transfer end/break interrupt (DTE = 0 and DTIE = 1)
• TEND pin enable (TEE = 1)
• DACK pin enable (FAE = 0 and SAE = 1)
Page 424 of 1448
register is read as shown in figure 8.44.
Module Stop
φ
DMA internal
address
DMA register
operation
DMA control
Figure 8.44 Contention between DMAC Register Update and CPU Read
Note: The lower word of MAR is the updated value after the operation in [1].
MAR upper
word read
Idle
CPU longword read
[1]
MAR lower
word read
Transfe
source
Read
[2]
DMA read
destination
DMA transfer cycle
Transfer
Write
H8S/2427, H8S/2427R, H8S/2425 Group
DMA write
Idle
REJ09B0565-0100 Rev. 1.00
Jul 22, 2010