SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 246

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

22.12.2
Figure 22-32. Clock Rate Transition Occurs while the SMC is Performing a Write Operation
222
internal signal from PMC
AT91SAM9263
Switching from (to) Slow Clock Mode to (from) Normal Mode
Slow Clock Mode
NBS0, NBS1,
NBS2, NBS3,
A0,A1
This write cycle finishes with the slow clock mode set
A
[25:2]
NWE
MCK
NCS
of parameters after the clock rate transition
When switching from slow clock mode to the normal mode, the current slow clock mode transfer
is completed at high clock rate, with the set of slow clock mode parameters.See
page
Figure 22-33
other.
222. The external device may not be fast enough to support such timings.
SLOW CLOCK MODE WRITE
1
NWE_CYCLE = 3
illustrates the recommended procedure to properly switch from one mode to the
1
1
SLOW CLOCK MODE WRITE
1
1
Slow clock mode transition is detected:
1
Reload Configuration Wait State
2
NORMAL MODE WRITE
NWE_CYCLE = 7
3
2
6249I–ATARM–3-Oct-11
Figure 22-32 on