SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 651

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

37.3
37.4
Table 37-1.
37.5
37.5.1
37.5.2
37.5.3
6249I–ATARM–3-Oct-11
Name
CANRX
CANTX
Application Block Diagram
I/O Lines Description
Product Dependencies
I/O Lines
Power Management
Interrupt
I/O Lines Description
Description
CAN Receive Serial Data
CAN Transmit Serial Data
Figure 37-2.
The pins used for interfacing the CAN may be multiplexed with the PIO lines. The programmer
must first program the PIO controller to assign the desired CAN pins to their peripheral function.
If I/O lines of the CAN are not used by the application, they can be used for other purposes by
the PIO Controller.
The programmer must first enable the CAN clock in the Power Management Controller (PMC)
before using the CAN.
A Low-power Mode is defined for the CAN controller: If the application does not require CAN
operations, the CAN clock can be stopped when not needed and be restarted later. Before stop-
ping the clock, the CAN Controller must be in Low-power Mode to complete the current transfer.
After restarting the clock, the application must disable the Low-power Mode of the CAN
controller.
The CAN interrupt line is connected on one of the internal sources of the Advanced Interrupt
Controller. Using the CAN interrupt requires the AIC to be programmed first. Note that it is not
recommended to use the CAN interrupt line in edge-sensitive mode.
Application Block Diagram
CAN-based Application Layer
CAN Data Link Layer
CAN-based Profiles
CAN Physical Layer
Layers
Implementation
CAN Controller
Transceiver
Software
Software
AT91SAM9263
Type
Input
Output
651