SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 910

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

910
AT91SAM9263
The LCDVSYNC is asserted once per frame. This signal is asserted to cause the LCD's line
pointer to start over at the top of the display. The timing of this signal depends on the type of
LCD: STN or TFT LCD.
In STN mode, the high phase corresponds to the complete first line of the frame. In STN mode,
this signal is synchronized with the first active LCDDOTCK rising edge in a line.
In TFT mode, the high phase of this signal starts at the beginning of the first line. The following
timing parameters can be selected:
There are two other parameters to configure in this module, the HOZVAL and the LINEVAL
fields of the LCDFRMCFG:
Figure
SYNC and LCDVSYNC signals:
• Vertical Pulse Width (VPW): LCDVSYNC pulse width is configurable in VPW field of the
• Vertical Back Porch: Number of inactive lines at the beginning of the frame is configurable in
• Vertical Front Porch: Number of inactive lines at the end of the frame is configurable in VFP
• HOZVAL configures the number of active LCDDOTCK cycles in each line. The number of
• LINEVAL configures the number of active lines per frame. This number is equal to
LCDTIM1 register. The pulse width is equal to (VPW+1) lines.
VBP field of LCDTIM1 register. The number of inactive lines is equal to VBP. This field should
be programmed with 0 in STN Mode.
field of LCDTIM2 register. The number of inactive lines is equal to VFP. This field should be
programmed with 0 in STN mode.
active cycles in each line is equal to (HOZVAL+1) cycles. The minimum value of this
parameter is 1.
(LINEVAL+1) lines. The minimum value of this parameter is 1.
44-3,
Figure 44-4
and
Figure 44-5
show the timing of LCDDOTCK, LCDDEN, LCDH-
6249I–ATARM–3-Oct-11