SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 44

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

10.5.6
10.5.7
10.5.8
10.5.9
44
AT91SAM9263
Timer Counter
Pulse Width Modulation Controller
Multimedia Card Interface
CAN Controller
• Three 16-bit Timer Counter Channels
• Wide range of functions including:
• Each channel is user-configurable and contains:
• Two global registers that act on all three TC Channels
• 4 channels, one 16-bit counter per channel
• Common clock generator, providing thirteen different clocks
• Independent channel programming
• Two double-channel Multimedia Card Interfaces, allowing concurrent transfers with 2 cards
• Compatibility with MultiMediaCard Specification Version 3.31
• Compatibility with SD Memory Card Specification Version 1.0
• Compatibility with SDIO Specification Version V1.1
• Cards clock rate up to Master Clock divided by 2
• Embedded power management to slow down clock rate when not used
• Each MCI has two slots, each supporting
• Support for stream, block and multi-block data read and write
• Fully compliant with 16-mailbox CAN 2.0A and 2.0B CAN Controllers
– Frequency Measurement
– Event Counting
– Interval Measurement
– Pulse Generation
– Delay Timing
– Pulse Width Modulation
– Up/down Capabilities
– Three external clock inputs
– Five internal clock inputs
– Two multi-purpose input/output signals
– Modulo n counter providing eleven clocks
– Two independent Linear Dividers working on modulo n counter outputs
– Independent Enable Disable commands
– Independent clock selection
– Independent period and duty cycle, with double bufferization
– Programmable selection of the output waveform polarity
– Programmable center or left aligned output waveform
– One slot for one MultiMediaCard bus (up to 30 cards) or
– One SD Memory Card
6249I–ATARM–3-Oct-11