DF2148RTE20IV Renesas Electronics America, DF2148RTE20IV Datasheet - Page 504

• Manufacturer Part Number: DF2148RTE20IV
• Description: MCU 5V 128K I-TEMP,PB-FREE, 100-
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2148RTE20IV

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: Host Interface, I²C, IrDA, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 15 Serial Communication Interface (SCI, IrDA)
Figure 15.4 shows a sample SCI initialization flowchart.
Rev. 4.00 Sep 27, 2006 page 458 of 1130
REJ09B0327-0400
Set CKE1 and CKE0 bits in SCR
SCR to 1, and set RIE, TIE, TEIE,
Clear TE and RE bits in SCR to 0
Set data transfer format in
<Initialization completed>
1-bit interval elapsed?
Set TE and RE bits in
SMR and SCMR
Set value in BRR
Start initialization
(TE, RE bits 0)
and MPIE bits
Figure 15.4 Sample SCI Initialization Flowchart
Yes
Wait
No
[1]
[2]
[3]
[4]
[1] Set the clock selection in SCR.
[2] Set the data transfer format in SMR
[3] Write a value corresponding to the
[4] Wait at least one bit interval, then
Be sure to clear bits RIE, TIE,
TEIE, and MPIE, and bits TE and
RE, to 0.
When the clock is selected in
asynchronous mode, it is output
immediately after SCR settings are
made.
and SCMR.
bit rate to BRR. This is not
necessary if an external clock is
used.
set the TE bit or RE bit in SCR to 1.
Also set the RIE, TIE, TEIE, and
MPIE bits.
Setting the TE and RE bits enables
the TxD and RxD pins to be used.