HD6417320 RENESAS [Renesas Technology Corp], HD6417320 Datasheet - Page 486

• Manufacturer Part Number: HD6417320
• Description: Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7700 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 10
10.4
When there is a DMA transfer request, the DMAC starts the transfer according to the
predetermined channel priority; when the transfer end conditions are satisfied, it ends the transfer.
Transfers can be requested in three modes: auto request, external request, and on-chip peripheral
module request. In bus mode, burst mode or cycle steal mode can be selected.
10.4.1
After the DMA source address registers (SAR), DMA destination address registers (DAR), DMA
transfer count registers (DMATCR), DMA channel control registers (CHCR), DMA operation
register (DMAOR), and DMA extended resource selectors (DMARS) are set, the DMAC transfers
data according to the following procedure:
1. Checks to see if transfer is enabled (DE = 1, DME = 1, TE = 0, AE = 0, NMIF = 0)
2. When a transfer request occurs while transfer is enabled, the DMAC transfers one transfer unit
3. When the specified number of transfer have been completed (when DMATCR reaches 0), the
4. When an address error or an NMI interrupt is generated, the transfer is aborted. Transfers are
Rev. 3.00 Jan. 18, 2008 Page 424 of 1458
REJ09B0033-0300
of data (depending on the TS0 and TS1 settings). In auto request mode, the transfer begins
automatically when the DE bit and DME bit are set to 1. The DMATCR value will be
decremented for each transfer. The actual transfer flows vary by address mode and bus mode.
transfer ends normally. If the IE bit in CHCR is set to 1 at this time, a DEI interrupt is sent to
the CPU.
also aborted when the DE bit in CHCR or the DME bit in DMAOR is changed to 0.
Operation
DMA Transfer Flow
Direct Memory Access Controller (DMAC)