HD6417320 RENESAS [Renesas Technology Corp], HD6417320 Datasheet - Page 97

• Manufacturer Part Number: HD6417320
• Description: Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7700 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Notes: 1. All Vcc/Vss/VccQ/VssQ/VccQ1/VssQ1/AVcc/AVss/AVcc_USB/AVss_USB/VccQ_RTC/
Classification
Advanced user
debugger
(AUD)
E10A interface
2. Always supply power to the Vcc_RTC and VccQ_RTC, even if the RTC is not being
3. Always supply power to the Vcc_PLL1 and Vcc_PLL2, even if the PLL is not being
4. Drive ASEMD0 high when using the user system alone, and not using an emulator or
5. Drivability can be switched by the register settings of the pin function controller (PFC).
6. SDHI associated pins support only for the models including the SDHI.
Vcc_RTC/Vss_RTC/Vcc_PLL1/Vss_PLL1/Vcc_PLL2/Vss_PLL2 should be connected to
the system power supply (so that power is supplied at all times.) In hardware standby
mode, the power supply to other than Vcc_RTC and VccQ_RTC can be turned off
(section 13.8).
used.
used.
the H-UDI. When this pin is low or open, RESETP may be masked.
When 3.3 V is applied to VccQ1, set the drivability low. When 1.8 V is applied to
VccQ1, set the drivability high.
Symbol
AUDATA3 to
AUDATA0
AUDCK
AUDSYNC
ASEBRKAK
ASEMD0
I/O
O
O
O
O
I
Name
AUD data
AUD clock
AUD
synchronous
signal
ASE break
mode
acknowledge
ASE mode
Rev. 3.00
Function
Destination-address output pin in
branch-trace mode
Synchronous clock output pin in
branch-trace mode
Data start-position acknowledge-
signal output pin in branch-trace
mode
Indicates that the E10A emulator
has entered its break mode.
Sets ASE mode.
Jan. 18, 2008
Section 1
REJ09B0033-0300
Page 35 of 1458
Overview