DF2170BVTE33V Renesas Electronics America, DF2170BVTE33V Datasheet - Page 453

• Manufacturer Part Number: DF2170BVTE33V
• Description: IC H8S/2170 MCU FLASH 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2170BVTE33V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: SCI, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 76
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)3DK2166 - DEV EVAL KIT H8S/2166
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -

6. After programming/erasing, the flash memory should be inhibited until FKEY is cleared.
7. Switching of the MATs by FMATS should be needed when programming/erasing of the user
8. When the data storable area indicated by programming parameter FMPDR is within the flash
In consideration of these conditions, there are three factors; operating mode, the bank structure of
the user MAT, and operations.
The areas in which the programming data can be stored for execution are shown in tables.
Table 14.8 Executable MAT
Note:
Operation
Programming
Erasing
The reset state (RES = 0) must be in place for more than 100 µs when the LSI mode is changed
to reset on completion of a programming/erasing operation.
Transitions to the reset state, and hardware standby mode are inhibited during
programming/erasing. When the reset signal is accidentally input to the chip, a longer period in
the reset state than usual (100 µs) is needed before the reset signal is released.
boot MAT is operated in user-boot mode. The program which switches the MATs should be
executed from the on-chip RAM. See section 14.6, Switching between User MAT and User
Boot MAT. Please make sure you know which MAT is selected when switching between
them.
memory area, an error will occur even when the data stored is normal. Therefore, the data
should be transferred to the on-chip RAM to place the address that FMPDR indicates in an
area other than the flash memory.
*
Programming/Erasing is possible to user MATs.
User Program Mode
Table 14.9 (1)
Table 14.9 (2)
Initiated Mode
Rev. 2.00, 03/04, page 419 of 534
User Boot Mode*
Table 14.9 (3)
Table 14.9 (4)