DF2170BVTE33V Renesas Electronics America, DF2170BVTE33V Datasheet - Page 483

• Manufacturer Part Number: DF2170BVTE33V
• Description: IC H8S/2170 MCU FLASH 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2170BVTE33V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: SCI, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 76
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)3DK2166 - DEV EVAL KIT H8S/2166
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -

Transition to Programming/Erasing State: The boot program will transfer the erasing program,
and erase the user MATs and user boot MATs in that order. On completion of this erasure, ACK
will be returned and will enter the programming/erasing state.
The host should select the device code, clock mode, and new bit rate with device selection, clock-
mode selection, and new bit-rate selection commands, and then send the command for the
transition to programming/erasing state. These procedures should be carried out before sending of
the programming selection command or program data.
• Command, H'40, (one byte): Transition to programming/erasing state
• Response, H'06, (one byte): Response to transition to programming/erasing state
• Error response, H'C0, (one byte): Error response for user boot MAT blank check
• Error code, H'51, (one byte): Erasing error
Command Error: A command error will occur when a command is undefined, the order of
commands is incorrect, or a command is unacceptable. Issuing a clock-mode selection command
before a device selection or an inquiry command after the transition to programming/erasing state
command, are examples.
• Error response, H'80, (one byte): Command error
• Command, H'xx, (one byte): Received command
Command Order: The order for commands in the inquiry selection state is shown below.
1. A supported device inquiry (H'20) should be made to inquire about the supported devices.
2. The device should be selected from among those described by the returned information and set
3. A clock-mode inquiry (H'21) should be made to inquire about the supported clock modes.
4. The clock mode should be selected from among those described by the returned information
5. After selection of the device and clock mode, inquiries for other required information should
Command
Response
Error Response
Error Response
The boot program will send ACK when the user MAT and user boot MAT have been erased
by the transferred erasing program.
An error occurred and erasure was not completed.
with a device-selection (H'10) command.
and set.
be made, such as the multiplication-ratio inquiry (H'22) or operating frequency inquiry (H'23),
which are needed for a new bit-rate selection.
H'40
H'06
H'C0
H'80
H'51
H'xx
Rev. 2.00, 03/04, page 449 of 534