PEF 20532 F V1.3 Infineon Technologies, PEF 20532 F V1.3 Datasheet - Page 224

no-image

PEF 20532 F V1.3

Manufacturer Part Number
PEF 20532 F V1.3
Description
IC COMM CTRLR 2CH SER TQFP-100
Manufacturer
Infineon Technologies
Datasheet

Specifications of PEF 20532 F V1.3

Function
Serial Optimized Communications Controller
Interface
ASYNC, BISYNC, HDLC, PPP
Number Of Circuits
2
Voltage - Supply
3 V ~ 3.6 V
Current - Supply
50mA
Power (watts)
150mW
Operating Temperature
-40°C ~ 85°C
Mounting Type
Surface Mount
Package / Case
100-LFQFP
Includes
Automatic Flag Detection and Transmission, Baud Rate Generator, On-Chip Clock Generation, Receive Line Status Detection
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
PEF20532FV1.3X
PEF20532FV13XP
SP000007511
Data Sheet
XPR
ALLS
XDU
XON
Transmit Pool Ready Interrupt
This bit is set to ’1’, if a transmitter reset command was executed
successfully (command bit ’XRES’ in register CMDRL) and whenever
the XFIFO is able to accept new transmit data again.
An ’XPR’ interrupt is not generated, if no sufficient transmit clock is
available (depending on the selected clock mode).
ALL Sent Interrupt
HDLC Mode:
This bit is set to ’1’:
• if the last bit of the current HDLC frame is sent out via pin TxD and no
• if an I-frame is sent out completely via pin TxD and either a valid
ASYNC/BISYNC Mode:
This bit is set to ’1’, if the last character is completely sent via pin TxD
and no further data is stored in the SCC transmit FIFO, i.e. the transmit
FIFO is empty.
Transmit Data Underrun Interrupt
This bit is set to ’1’, if the current frame was terminated by the SCC with
an abort sequence, because neither a ’frame end / block end’ indication
was detected in the FIFO (to complete the current frame) nor more data
is available in the SCC transmit FIFO.
Note: The transmitter is stopped if this condition occurs. The XDU
XON Character Detected Interrupt
This bit is set to ’1’, if the currently received character matched the XON
character programmed in register
transmitter is switched to ’XON’ state if in-band flow control is enabled
via bit ’FLON’ in register CCR2H.
further frame is stored in the SCC transmit FIFO, i.e. the transmit FIFO
is empty (Address Mode 2/1/0);
acknowledge S-frame has been received or a time-out condition
occured because no valid acknowledge S-frame has been received in
time (Automode).
condition MUST be cleared by reading register ISR1, thus bit
’XDU’ should not be masked via register IMR1.
224
XON
and indicates, that the
Register Description
(hdlc/bisync modes)
(async mode)
PEB 20532
PEF 20532
(all modes)
(all modes)
2000-09-14

Related parts for PEF 20532 F V1.3