HD6417720BP133BV Renesas Electronics America, HD6417720BP133BV Datasheet - Page 1092

• Manufacturer Part Number: HD6417720BP133BV
• Description: SH3-DSP, WITH USB AND LCDC, PB-F
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417720BP133BV

• Core Processor: SH-3 DSP
• Core Size: 32-Bit
• Speed: 133MHz
• Connectivity: FIFO, I²C, IrDA, MMC, SCI, SD, SIO, SIM, USB
• Peripherals: DMA, LCD, POR, WDT
• Number Of I /o: 117
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.4 V ~ 1.6 V
• Data Converters: A/D 4x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 256-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

Section 31 MultiMediaCard Interface (MMCIF)
Table 31.2 summarizes the correspondence between the commands described in the
MultiMediaCard System Specification Version 3.1 and the settings of CMDTYR and RSPTYR.
Page 1032 of 1414
Bit
7
6
5
4
3
2
1
0
Bit Name
—
TY6
TY5
TY4
TY3
TY2
TY1
TY0
Initial
Value
0
0
0
0
0
0
0
0
R/W
R
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Description
Reserved
This bit is always read as 0. The write value should always
be 0.
Specifies the pre-defined multiblock transfer. Bits TY1 and
TY0 should be set to 01 or 10.
When the command which specifies this bit is used, the
transfer block size and the number of transfer blocks should
be specified in TBCR and TBNCR, respectively.
Specifies the multiblock transfer while the secure MMC is
used. Bits TY1 and TY0 should be set to 01 or 10.
When the command which specifies this bit is used, the
transfer block size and the number of transfer blocks should
be specified in TBCR and TBNCR, respectively.
This bit is set to 1 when the CMD12 command is issued. Bits
TY1 and TY0 should be set to 00.
Specifies the stream transfer. Bits TY1 and TY0 should be
set to 01 or 10. The stream transfer can be used only in
MMC mode.
The command sequence of the stream transfer specified by
this bit ends when it is stopped by the CMD12 command.
Specifies the open-ended multiblock transfer. Bits TY1 and
TY0 should be set to 01 or 10.
The command sequence of the stream transfer specified by
this bit ends when it is stopped by the CMD12 command.
Specify the existence and direction of transfer data.
00: A command without data transfer
01: A command with read data reception
10: A command with write data transmission
11: Setting prohibited
SH7720 Group, SH7721 Group
R01UH0083EJ0400 Rev. 4.00
Sep 21, 2010