HD6417720BP133BV Renesas Electronics America, HD6417720BP133BV Datasheet - Page 484

• Manufacturer Part Number: HD6417720BP133BV
• Description: SH3-DSP, WITH USB AND LCDC, PB-F
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417720BP133BV

• Core Processor: SH-3 DSP
• Core Size: 32-Bit
• Speed: 133MHz
• Connectivity: FIFO, I²C, IrDA, MMC, SCI, SD, SIO, SIM, USB
• Peripherals: DMA, LCD, POR, WDT
• Number Of I /o: 117
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.4 V ~ 1.6 V
• Data Converters: A/D 4x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 256-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

Section 10 Direct Memory Access Controller (DMAC)
10.4
When there is a DMA transfer request, the DMAC starts the transfer according to the
predetermined channel priority; when the transfer end conditions are satisfied, it ends the transfer.
Transfers can be requested in three modes: auto request, external request, and on-chip peripheral
module request. In bus mode, burst mode or cycle steal mode can be selected.
10.4.1
After the DMA source address registers (SAR), DMA destination address registers (DAR), DMA
transfer count registers (DMATCR), DMA channel control registers (CHCR), DMA operation
register (DMAOR), and DMA extended resource selectors (DMARS) are set, the DMAC transfers
data according to the following procedure:
1. Checks to see if transfer is enabled (DE = 1, DME = 1, TE = 0, AE = 0, NMIF = 0)
2. When a transfer request occurs while transfer is enabled, the DMAC transfers one transfer unit
3. When the specified number of transfer have been completed (when DMATCR reaches 0), the
4. When an address error or an NMI interrupt is generated, the transfer is aborted. Transfers are
Page 424 of 1414
of data (depending on the TS0 and TS1 settings). In auto request mode, the transfer begins
automatically when the DE bit and DME bit are set to 1. The DMATCR value will be
decremented for each transfer. The actual transfer flows vary by address mode and bus mode.
transfer ends normally. If the IE bit in CHCR is set to 1 at this time, a DEI interrupt is sent to
the CPU.
also aborted when the DE bit in CHCR or the DME bit in DMAOR is changed to 0.
Operation
DMA Transfer Flow
SH7720 Group, SH7721 Group
R01UH0083EJ0400 Rev. 4.00
Sep 21, 2010