DF2110BVTE10 Renesas Electronics America, DF2110BVTE10 Datasheet - Page 100

• Manufacturer Part Number: DF2110BVTE10
• Description: MCU 3V 64K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2110BVTE10

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 10MHz
• Connectivity: Host Interface (LPC), I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 82
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Data Converters: -
• Other names: HD64F2110BVTE10; HD64F2110BVTE10

Section 4 Exception Handling
4.3.2
If an interrupt is accepted after a reset and before the stack pointer (SP) is initialized, the PC and
CCR will not be saved correctly, leading to a program crash. To prevent this, all interrupt requests,
including NMI, are disabled immediately after a reset. Since the first instruction of a program is
always executed immediately after the reset state ends, make sure that this instruction initializes
the stack pointer (example: MOV.L #xx: 32, SP).
4.3.3
After a reset is cancelled, the module stop control registers (MSTPCR) are initialized, and all
modules operate in module stop mode. Therefore, the registers of on-chip peripheral modules
cannot be read from or written to. To read from and write to these registers, clear module stop
mode.
4.4
Interrupts are controlled by the interrupt controller. The sources to start interrupt exception
handling are external interrupt sources (NMI, IRQ7 to IRQ0, KIN15 to KIN0, and WUE7 to
WUE0) and internal interrupt sources from the on-chip peripheral modules. NMI is an interrupt
with the highest priority. For details, refer to section 5, Interrupt Controller.
Interrupt exception handling is conducted as follows:
1. The values in the program counter (PC) and condition code register (CCR) are saved to the
2. A vector address corresponding to the interrupt source is generated, the start address is loaded
4.5
Trap instruction exception handling starts when a TRAPA instruction is executed. Trap instruction
exception handling can be executed at all times in the program execution state.
Trap instruction exception handling is conducted as follows:
1. The values in the program counter (PC) and condition code register (CCR) are saved to the
2. A vector address corresponding to the interrupt source is generated, the start address is loaded
Rev. 2.00 Mar 21, 2006 page 60 of 518
REJ09B0299-0200
stack.
from the vector table to the PC, and program execution begins from that address.
stack.
from the vector table to the PC, and program execution starts from that address.
Interrupts after Reset
On-Chip Peripheral Modules after Reset Is Cancelled
Interrupt Exception Handling
Trap Instruction Exception Handling