DF2110BVTE10 Renesas Electronics America, DF2110BVTE10 Datasheet - Page 366

• Manufacturer Part Number: DF2110BVTE10
• Description: MCU 3V 64K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2110BVTE10

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 10MHz
• Connectivity: Host Interface (LPC), I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 82
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Data Converters: -
• Other names: HD64F2110BVTE10; HD64F2110BVTE10

Section 13 I
The following items are not initialized:
Notes on Initialization:
The value of the BBSY bit cannot be modified directly by this module clear function, but since the
stop condition pin waveform is generated according to the state and release timing of the SCL and
SDA pins, the BBSY bit may be cleared as a result. Similarly, state switching of other bits and
flags may also have an effect.
To prevent problems caused by these factors, the following procedure should be used when
1. Execute initialization of the internal state according to the setting of bits CLR3 to CLR0 or
2. Execute a stop condition issuance instruction (write 0 to BBSY and SCP) to clear the BBSY
3. Re-execute initialization of the internal state according to the setting of bits CLR3 to CLR0 or
4. Initialize (re-set) the IIC registers.
Rev. 2.00 Mar 21, 2006 page 326 of 518
REJ09B0299-0200
Actual register values (ICDR, SAR, SARX, ICMR, ICCR, ICSR, ICXR (except for the ICDRE
and ICDRF flags)
Internal latches used to retain register read information for setting/clearing flags in ICMR,
ICCR, and ICSR
The value of the ICMR bit counter (BC2 to BC0)
Generated interrupt sources (interrupt sources transferred to the interrupt controller)
Interrupt flags and interrupt sources are not cleared, and so flag clearing measures must be
taken as necessary.
Basically, other register flags are not cleared either, and so flag clearing measures must be
taken as necessary.
When initialization is executed by DDCSWR, the write data for bits CLR3 to CLR0 is not
retained. To perform IIC clearance, bits CLR3 to CLR0 must be written to simultaneously
using an MOV instruction. Do not use a bit manipulation instruction such as BCLR.
Similarly, when clearing is required again, all the bits must be written to simultaneously in
accordance with the setting.
If a flag clearing setting is made during transmission/reception, the IIC module will stop
transmitting/receiving at that point and the SCL and SDA pins will be released. When
transmission/reception is started again, register initialization, etc., must be carried out as
necessary to enable correct communication as a system.
initializing the IIC state.
ICE bit clearing.
bit to 0, and wait for two transfer rate clock cycles.
ICE bit clearing.
2
C Bus Interface (IIC)