DF2110BVTE10 Renesas Electronics America, DF2110BVTE10 Datasheet - Page 472

• Manufacturer Part Number: DF2110BVTE10
• Description: MCU 3V 64K 100-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2110BVTE10

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 10MHz
• Connectivity: Host Interface (LPC), I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 82
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Data Converters: -
• Other names: HD64F2110BVTE10; HD64F2110BVTE10

Section 17 ROM
4. Do not set/clear the SWE bit during program execution in the flash memory.
5. Do not use interrupts during flash memory programming/erasing
6. Do not perform additional programming. Programming must be performed in the erased state.
7. Ensure that the PROM programmer is correctly attached before programming.
8. Do not touch the socket adapter or LSI while programming.
Rev. 2.00 Mar 21, 2006 page 432 of 518
REJ09B0299-0200
Do not set/clear the SWE bit during program execution in the flash memory. An interval of at
least 100 s is necessary between program execution or data reading in flash memory and
SWE bit clearing. When the SWE bit is set to 1, flash memory data can be modified, however,
flash memory data can be read only in program-verify or erase-verify mode. Do not access the
flash memory for a purpose other than verification during programming/erasing. Do not clear
the SWE bit during programming, erasing, or verifying.
In order to give the highest priority to programming/erasing operation, disable all interrupts
including NMI input when the flash memory is programmed or erased.
Program the area with 128-byte programming-unit blocks in on-board programming or
programmer mode only once. Perform programming in the state where the programming-unit
block is fully erased.
If the socket, socket adapter, or product index does not match the specifications, too much
current flows and the product may be damaged.
Touching either of these can cause contact faults and write errors.