UPD78F1000GB-GAF-AX Renesas Electronics America, UPD78F1000GB-GAF-AX Datasheet - Page 473

• Manufacturer Part Number: UPD78F1000GB-GAF-AX
• Description: MCU 16BIT 78K0R/KX3-L 44-LQFP
• Manufacturer: Renesas Electronics America
• Series: 78K0R/Kx3-Lr

Specifications of UPD78F1000GB-GAF-AX

• Core Processor: 78K/0R
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: 3-Wire SIO, I²C, LIN, UART/USART
• Peripherals: DMA, LVD, POR, PWM, WDT
• Number Of I /o: 33
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 10x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

78K0R/Kx3-L
R01UH0106EJ0300 Rev.3.00
Oct 01, 2010
TAU
default
setting
Channel
default
setting
(Note and Remark are listed on the next page.)
Sets the TAU0EN and TAU1EN bits of peripheral enable
registers 0, 2 (PER0, PER2) to 1.
Sets timer clock select register m (TPSm).
Sets timer mode register mn, mp (TMRmn, TMRmp) of
two channels to be used (determines operation mode of
channels).
An output delay is set to timer data register mn (TDRmn)
of the master channel, and a pulse width is set to the
TDRmp register of the slave channel.
Sets slave channel.
The TOMmp bit of timer output mode register m
(TOMm) is set to 1 (slave channel output mode).
Sets the TOLmp bit.
Sets the TOmp bit and determines default level of the
TOmp output.
Sets the TOEmp bit to 1 and enables operation of TOmp.
Clears the port register and port mode register to 0.
Determines clock frequencies of CKm0 and CKm1.
Figure 8-65. Operation Procedure of One-Shot Pulse Output Function (1/2)
Software Operation
Note
Power-off status
Power-on status. Each channel stops operating.
Channel stops operating.
(Clock is supplied and some power is consumed.)
The TOmp pin goes into Hi-Z output state.
The TOmp default setting level is output when the port
mode register is in output mode and the port register is 0.
TOmp does not change because channel stops operating.
The TOmp pin outputs the TOmp set level.
(Clock supply is stopped and writing to each register is
disabled.)
(Clock supply is started and writing to each register is
enabled.)
CHAPTER 8 TIMER ARRAY UNIT
Hardware Status
473