HD64F2318VTE25 Renesas Electronics America, HD64F2318VTE25 Datasheet - Page 137

• Manufacturer Part Number: HD64F2318VTE25
• Description: IC H8S MCU FLASH 256K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of HD64F2318VTE25

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 71
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

4.2.3
If an interrupt is accepted after a reset but before the stack pointer (SP) is initialized, the PC and
CCR will not be saved correctly, leading to a program crash. To prevent this, all interrupt requests,
including NMI, are disabled immediately after a reset. Since the first instruction of a program is
always executed immediately after the reset state ends, make sure that this instruction initializes
the stack pointer (example: MOV.L #xx:32, SP).
4.2.4
After reset release, MSTPCR is initialized to H'3FFF and all modules except the DTC enter
module stop mode. Consequently, on-chip supporting module registers cannot be read or written
to. Register reading and writing is enabled when module stop mode is exited.
RES
Address bus
RD
HWR, LWR
D
(1), (3) Reset exception handling vector address ((1) = H'000000, (3) = H'000002)
(2), (4) Start address (contents of reset exception vector address)
(5)
(6)
Note: * 3 program wait states are inserted.
15
Interrupts after Reset
State of On-Chip Supporting Modules after Reset Release
to D
φ
0
Start address ((5) = (2), (4))
First program instruction
Figure 4.2 Reset Sequence (Mode 4)
*
(1)
Vector fetch
(2)
Rev.7.00 Feb. 14, 2007 page 103 of 1108
High
*
(3)
Internal
processing
(4)
Section 4 Exception Handling
Prefetch of first
program instruction
(5)
*
REJ09B0089-0700
(6)