HD64F2318VTE25 Renesas Electronics America, HD64F2318VTE25 Datasheet - Page 895

• Manufacturer Part Number: HD64F2318VTE25
• Description: IC H8S MCU FLASH 256K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of HD64F2318VTE25

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 71
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

20.3.7
The H8S/2319C F-ZTAT has an on-chip voltage step down circuit that automatically lowers the
power supply voltage, inside the microcomputer, to an adequate level. A capacitor (0.1 µF) should
be connected between the internal voltage step down circuit pin (V
stabilize the internal voltage. Figure 20.23 shows how to connect the capacitor. Do not connect the
V
power-supply to the V
20.4
Although both the F-ZTAT and mask ROM versions fully meet the electrical specifications listed
in this manual, there may be differences in the actual values of the electrical characteristics,
operating margins, noise margins, and so forth, due to differences in the fabrication process, the
on-chip ROM, and the layout patterns.
If the F-ZTAT version is used to carry out system evaluation and testing, therefore, when
switching to the mask ROM version the same evaluation and testing procedures should also be
conducted on this version.
CC
power supply to the V
Usage Note (Internal voltage step down for the H8S/2319C F-ZTAT)
Usage Note
CC
Figure 20.23 V
Do not connect the V
Doing so could permanently damage the LSI. (Connect
the V
Use a multilayer ceramic capacitor (0.1 μF), and place
it near the pins.
pin, in the usual way.)
CL
External capacitor
to stabilize the
power supply
CC
pin. Doing so could permanently damage the LSI. (Connect the V
power-supply to the V
0.1 μF
CL
Capacitor Connection Method
CC
power-supply to the V
V
V
CL
SS
CC
pin, in the usual way.)
Rev.7.00 Feb. 14, 2007 page 861 of 1108
Section 20 Electrical Characteristics
CL
CL
pin.
pin) and the V
REJ09B0089-0700
SS
pin to
CC