HD64F2318VTE25 Renesas Electronics America, HD64F2318VTE25 Datasheet - Page 152

• Manufacturer Part Number: HD64F2318VTE25
• Description: IC H8S MCU FLASH 256K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of HD64F2318VTE25

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 71
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 5 Interrupt Controller
Figure 5.3 shows the timing of setting IRQnF.
The vector numbers for IRQ7 to IRQ0 interrupt exception handling are 23 to 16.
Detection of IRQ7 to IRQ0 interrupts does not depend on whether the relevant pin has been set for
input or output. Therefore, when a pin is used as an external interrupt input pin, do not clear the
corresponding DDR bit to 0 and use the pin as an I/O pin for another function.
5.3.2
There are 43 sources for internal interrupts from on-chip supporting modules.
• For each on-chip supporting module there are flags that indicate the interrupt request status,
• The interrupt priority level can be set by means of IPR.
• The DTC can be activated by a TPU, SCI, or other interrupt request. When the DTC is
5.3.3
Table 5.4 shows interrupt exception handling sources, vector addresses, and interrupt priorities.
For default priorities, the lower the vector number, the higher the priority. The DTC can also be
activated by some interrupt sources.
Priorities among modules can be set by means of IPR. The situation when two or more modules
are set to the same priority, and priorities within a module, are fixed as shown in table 5.4.
Rev.7.00 Feb. 14, 2007 page 118 of 1108
REJ09B0089-0700
input pin
and enable bits that select enabling or disabling of these interrupts. If both of these are set to 1
for a particular interrupt source, an interrupt request is issued to the interrupt controller.
activated by an interrupt, the interrupt control mode and interrupt mask bits have no effect.
IRQnF
IRQn
φ
Internal Interrupts
Interrupt Exception Vector Table
Figure 5.3 Timing of Setting IRQnF