HD64F2318VTE25 Renesas Electronics America, HD64F2318VTE25 Datasheet - Page 779

• Manufacturer Part Number: HD64F2318VTE25
• Description: IC H8S MCU FLASH 256K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of HD64F2318VTE25

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 71
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

17.27.1 Usage Notes
1. Download time of on-chip program
2. Write to flash-memory related registers by DTC
3. Compatibility with programming/erasing program of conventional F-ZTAT H8S
The programming program that includes the initialization routine and the erasing program that
includes the initialization routine are each 2 kbytes or less. Accordingly, when the CPU clock
frequency is 25 MHz, the download for each program takes approximately 164 μs at
maximum.
While an instruction in on-chip RAM is being executed, the DTC can write to the SCO bit in
FCCS that is used for a download request or FMATS that is used for MAT switching. Make
sure that these registers are not accidentally written to, otherwise an on-chip program may be
downloaded and damage RAM or a MAT switchover may occur and the CPU get out of
control. Do not use DTC to program FLASH related registers.
microcomputer
A programming/erasing program for flash memory used in the conventional F-ZTAT H8S
microcomputer which does not support download of the on-chip program by a SCO transfer
request cannot run in this LSI.
Be sure to download the on-chip program to execute programming/erasing of flash memory in
this LSI.
< User MAT >
Figure 17.79 Switching between the User MAT and User Boot MAT
Procedure for switching to the user boot MAT
[1] Mask interrupts
[2] Write H'AA to the FMATS register.
[3] Execute 4 NOP instructions before
Procedure for switching to the user MAT
[1] Mask interrupts
[2] Write a value other than H'AA to the FMATS register.
[3] Execute 4 NOP instructions before or after accessing
accessing the user boot MAT.
the user MAT.
< On-chip RAM >
switching to the
user boot MAT
Procedure for
Procedure for
the user MAT
switching to
Rev.7.00 Feb. 14, 2007 page 745 of 1108
< User boot MAT >
REJ09B0089-0700
Section 17 ROM