HD64F2318VTE25 Renesas Electronics America, HD64F2318VTE25 Datasheet - Page 642

• Manufacturer Part Number: HD64F2318VTE25
• Description: IC H8S MCU FLASH 256K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of HD64F2318VTE25

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 71
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 17 ROM
17.11
17.11.1 Progremmer Mode Setting
Programs and data can be written and erased in programmer mode as well as in the on-board
programming modes. In programmer mode, the on-chip ROM can be freely programmed using a
PROM programmer * that supports the Renesas Technology microcomputer device type with 256-
kbyte on-chip flash memory (FZTAT256V3A). Flash memory read mode, auto-program mode,
auto-erase mode, and status read mode are supported with this device type. In auto-program
mode, auto-erase mode, and status read mode, a status polling procedure is used, and in status read
mode, detailed internal signals are output after execution of an auto-program or auto-erase
operation.
Note: * In the H8S/2315 F-ZTAT and H8S/2314 F-ZTAT, a PROM programmer that supports the
Table 17.13 shows programmer mode pin settings.
Table 17.13 Programmer Mode Pin Settings
Pin Names
Mode pins: MD2, MD1, MD0
Mode setting pins: PF2, PF1, PF0
FWE pin
STBY pin
NMI pin
RES pin
XTAL, EXTAL pins
Other pins requiring setting: P23, P25
Rev.7.00 Feb. 14, 2007 page 608 of 1108
REJ09B0089-0700
Renesas Technology microcomputer device type with 512-kbyte on-chip flash memory
(FZTAT512V3A) is used.
Flash Memory Programmer Mode
Settings/External Circuit Connection
Low-level input
High-level input to PF2, low-level input to PF1 and PF0
High-level input (in auto-program and auto-erase
modes)
High-level input (do not select hardware standby mode)
High-level input
Reset circuit
Oscillator circuit
High-level input to P23, low-level input to P25