L64105 LSI Logic Corporation, L64105 Datasheet - Page 135

no-image

L64105

Manufacturer Part Number
L64105
Description
Mpeg-2 Audio/video Decoder
Manufacturer
LSI Logic Corporation
Datasheet
Rip Forward Display Single Step Status
Rip Forward Display Single Step Command
Current Display Frame [1:0]
Microcontroller Registers
chroma on
active, the host must also specify the Override Picture
Width (Register 283, bits [6:0],
from the bitstream must be disabled (bit 6 in Register 279
must be cleared,
must be supplied by the host. Bit 2 in Register 275
(page
cleared, and the Host Repeat First Field bit (bit 3 in
Register 275) and Host Top Field First bit (bit 4 in
Register 275) must be used by the host to specify the
display completely.
Indicates the status of the Rip Forward Display Single
Step Command as described in the following bit.
This bit should be set by the host after it has made the
decision on whether or not to display the current picture.
The L64105’s microcontroller waits for this bit to be set
before continuing with picture reconstruction in Rip
Forward Mode. This bit is only applicable when the Rip
Forward Mode Enable bit (bit 0 in this register) is set. The
microcontroller clears this bit when it reads it.
These bits indicate which frame store is being used for
displaying the current frame as shown in the following
table.
Current Display
Frame
0b00
0b01
0b10
0b11
4-62), 3:2 Pulldown from Bitstream, must be
page
page
4-67). When Display Override Mode is
Description
Anchor 1
Anchor 2
B
Reserved
4-65) and pan-scan values (if any)
page
4-67). Pan and Scan
R [3:2]
W 1
4-53
R 1

Related parts for L64105