BMSKTOPASA900(DCE) Toshiba, BMSKTOPASA900(DCE) Datasheet - Page 323

• Manufacturer Part Number: BMSKTOPASA900(DCE)
• Description: KIT STARTER TMPA900 USB JTAG
• Manufacturer: Toshiba
• Series: TOPASr
• Type: MCUr

Specifications of BMSKTOPASA900(DCE)

• Contents: Evaluation Board, Cable(s), Software and Documentation
• For Use With/related Products: TMPA900CMXBG
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

[Description]
a. <STATE[3:0]>, <SERR[1:0]>,
b. <SELAL>
c. <ALS>
d. <ECCS>
Hamming codes are used, these bits have no meaning.
calculation results.
function is executed.
NAND-Flash at high speed by using the DMAC. Writing 1 to <ALS> enables the 16-byte
FIFO0/FIFO1.
(When 512-byte read or write is executed by the Autoload function, this register is cleared
to 0.)
This bit is set to 0 for using Hamming codes and to 1 for using Reed-Solomon codes. It is
also necessary to set this bit for resetting ECC.
The <STATE3:0> and <SEER1:0> bits are used only for Reed-Solomon codes. When
These bits are used as flags to indicate the states of error address and error bit
The <SELAL> bit is used for both Hamming and Reed-Solomon codes.
This bit is used to select data read or data write for the NAND-Flash when the Autoload
The <ALS> bit is used for both Hamming and Reed-Solomon codes.
This is the register that controls the function to transfer data read/write for the
In addition, a read operation allows the user to know the status of the Autoload function.
The <ECCS> bit is used to select whether to use Hamming codes or Reed-Solomon codes.
TENTATIVE
TMPA900CM- 322
TMPA900CM
2009-10-14