BMSKTOPASA900(DCE) Toshiba, BMSKTOPASA900(DCE) Datasheet - Page 594

• Manufacturer Part Number: BMSKTOPASA900(DCE)
• Description: KIT STARTER TMPA900 USB JTAG
• Manufacturer: Toshiba
• Series: TOPASr
• Type: MCUr

Specifications of BMSKTOPASA900(DCE)

• Contents: Evaluation Board, Cable(s), Software and Documentation
• For Use With/related Products: TMPA900CMXBG
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

“Set_configuration” and “Set_interface” requests, UDC2 will be in the “Configured”
status.
settings have been made.
have been made.
(4) When “Set_configuration” and “Set_interface” requests are received
• Set the maximum packet size to EPx_MaxPacketSize register
• Set the transfer mode to EPx_Status register
• Issue the EP_Reset command to Command register
Figure 3.16.18 shows the “Device State Diagram”.
By setting 0y100 to the bits[10:8] of Address-state register after receiving the
In the “Configured” status, you can make transfers to the endpoint to which status
In order to make the endpoint “Ready,” the following settings should be made:
Endpoints will be available for transmitting and receiving data after these settings
Address
assigned
Device
configured
Figure 3.16.18 Device state diagram
Configured
Addressed
! reset_x
Default
(HS)
(HS)
(HS)
TENTATIVE
TMPA900CM- 593
OK
deconfigured
Disconnect
(HS-Chirp)
Detect ?
(Invalid)
Default
Default
Device
Chirp
(FS)
deconfigured
command write
Device
"USB_RESET"
"usb_ready"
NG
! reset_x
Configured
Addressed
Detect
Default
(FS)
(FS)
(FS)
configured
assigned
Address
Device
TMPA900CM
2009-10-14