BMSKTOPASA900(DCE) Toshiba, BMSKTOPASA900(DCE) Datasheet - Page 554

• Manufacturer Part Number: BMSKTOPASA900(DCE)
• Description: KIT STARTER TMPA900 USB JTAG
• Manufacturer: Toshiba
• Series: TOPASr
• Type: MCUr

Specifications of BMSKTOPASA900(DCE)

• Contents: Evaluation Board, Cable(s), Software and Documentation
• For Use With/related Products: TMPA900CMXBG
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

(1) SIEC (Serial Interface Engine Control) block
(2) IFM block
(3) PVCIIF block
(4) EP0 block
(5) EPx block
bus (PVCI).
receiving data with DATA-Stage of Control transfers, you should access the FIFO in
this block via PVCI-I/F.
directly accessed via the Endpoint-I/F. The Endpoint-I/F can make burst transfers.
Direction of endpoints (send/receive) will be fixed on a hardware basis.
This block manages the protocol in USB. Its major functions are:
This block controls SIEC and endpoints. Its major functions are:
This block controls reading and writing between IFM and external register access
PVCI bus accesses via UDC2AB.
This block controls sending and receiving data in Control transfers. When sending or
This block controls sending and receiving data of EPx (x = 1, 2, 3). FIFO can be
Please note there are two endpoints; one for sending and another for receiving.
• Checks and generates PIDs.
• Checks and generates CRCs.
• Checks device addresses.
• Manages transfer speed (HS/FS).
• Controls PHY (transfer speed (HS/FS), mode, etc.).
• Generates test modes.
• Writes the received data to the relevant endpoints when received an
• Reads the transmit data from the relevant endpoints when an IN-Token is
• Controls and manages the status of UDC2.0.
OUT-Token.
received.
TENTATIVE
TMPA900CM- 553
TMPA900CM
2009-10-14