BMSKTOPASA900(DCE) Toshiba, BMSKTOPASA900(DCE) Datasheet - Page 821

• Manufacturer Part Number: BMSKTOPASA900(DCE)
• Description: KIT STARTER TMPA900 USB JTAG
• Manufacturer: Toshiba
• Series: TOPASr
• Type: MCUr

Specifications of BMSKTOPASA900(DCE)

• Contents: Evaluation Board, Cable(s), Software and Documentation
• For Use With/related Products: TMPA900CMXBG
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.24.2.4 AD Conversion Modes and AD Conversion End Interrupt
started, ADMOD0<ADBFN> is set to 1. When a specified AD conversion ends, the
Normal AD conversion end interrupt is generated, ADMOD0<EOCFN> is set 1 , shows
the end of the AD conversion sequence.
conversion, selection is available by setting ADMOD0<REPEAT and SCAN>. As for
top-priority AD conversion, only single conversion mode by channel fix mode is
available.
(1) Normal AD conversion
a. Channel-fix single conversion mode
b. Channel-scan single conversion mode
c. Channel-fix repeat conversion mode
a. Channel-fix single conversion mode
b. Channel-scan single conversion mode
c. Channel-fix repeat conversion mode
d. Channel-scan repeat conversion mode
To select operation modes, use ADMOD0<REPEAT, SCAN>. After AD conversion is
For AD conversion, the following four operation modes are provided: For normal AD
conversion mode.
conversion ends, ADMOD0<EOCFN> is set to 1, generating Normal AD
conversion End interrupt request. <EOCFN> is cleared to 0 only by being read.
conversion mode.
After scan conversion ends, ADMOD0<EOCFN> is set to 1, generating Normal
AD conversion End interrupt request. <EOCFN> is cleared to 0 only by being
read.
conversion mode.
conversion ends, ADMOD0<EOCFN> is set to 1. The timing of Normal AD
conversion End interrupt request generation can be selected by setting ADMOD0
<ITM>. The timing of <EOCFN> being set is also linked to the interrupt timing.
ends. In this case, conversion results are always stored into the storage register of
ADREGxH/L. At the point of storage, <EOCFN> is set to 1.
end. In this case, conversion results are stored into the storage registers of
ADREG0H/L to ADREG3H/L one after another. After stored into ADREG3,
<EOCFN> is set to 1, restarting storage from ADREG0. <EOCFN> is cleared to 0
only by being read.
Setting ADMOD0 <REPEAT, SCAN> to 0y00 selects the channel-fix single
This mode performs a conversion only one time at one channel selected. After
Setting ADMOD0 <REPEAT, SCAN> to 0y01 selects the channel-scan single
This mode performs a conversion only one time at each scan channel selected.
Setting ADMOD0<REPEAT, SCAN> to 0y10 selects the channel-fix repeat
This mode performs a conversion at one channel selected repeatedly. After
ADMOD0<EOCFN> is cleared to 0 only by being read.
Setting <ITM> to 0 generates an interrupt request each time an AD conversion
Setting <ITM> to 1 generates an interrupt request each time four AD conversions
TENTATIVE
TMPA900CM- 820
TMPA900CM
2009-10-14