DF61654N50FTV Renesas Electronics America, DF61654N50FTV Datasheet - Page 275

• Manufacturer Part Number: DF61654N50FTV
• Description: IC H8SX/1654 MCU FLASH 120TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8SX/1600r

Specifications of DF61654N50FTV

• Core Processor: H8SX
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: I²C, IrDA, SCI, SmartCard, USB
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 75
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 40K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)3DK1657 - DEV EVAL KIT FOR H8SX/1657
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

6.14.2
Even if a bus request is received from a bus master with a higher priority over that of the bus
master that has taken control of the bus and is currently operating, the bus is not necessarily
transferred immediately. There are specific timings at which each bus master can release the bus.
(1)
The CPU is the lowest-priority bus master, and if a bus request is received from the DTC or
DMAC, the bus arbiter transfers the bus to the bus master that issued the request.
The timing for transfer of the bus is at the end of the bus cycle. In sleep mode, the bus is
transferred synchronously with the clock.
Note, however, that the bus cannot be transferred in the following cases.
• The word or longword access is performed in some divisions.
• Stack handling is performed in multiple bus cycles.
• Transfer data read or write by memory transfer instructions, block transfer instructions, or TAS
• From the target read to write in the bit manipulation instructions or memory operation
(2)
The DTC sends the internal bus arbiter a request for the bus when an activation request is
generated. When the DTC accesses an external bus space, the DTC first takes control of the bus
from the internal bus arbiter and then requests a bus to the external bus arbiter.
Once the DTC takes control of the bus, the DTC continues the transfer processing cycles. If a bus
master whose priority is higher than the DTC requests the bus, the DTC transfers the bus to the
higher priority bus master. If the IBCCS bit in BCR2 is set to 1, the DTC transfers the bus to the
CPU.
Note, however, that the bus cannot be transferred in the following cases.
instruction.
(In the block transfer instructions, the bus can be transferred in the write cycle and the
following transfer data read cycle.)
instructions.
(In an instruction that performs no write operation according to the instruction condition, up to
a cycle corresponding the write cycle)
CPU
DTC
Bus Transfer Timing
Rev.1.00 Sep. 08, 2005 Page 225 of 966
Section 6 Bus Controller (BSC)
REJ09B0219-0100