DF61654N50FTV Renesas Electronics America, DF61654N50FTV Datasheet - Page 649

• Manufacturer Part Number: DF61654N50FTV
• Description: IC H8SX/1654 MCU FLASH 120TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8SX/1600r

Specifications of DF61654N50FTV

• Core Processor: H8SX
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: I²C, IrDA, SCI, SmartCard, USB
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 75
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 40K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)3DK1657 - DEV EVAL KIT FOR H8SX/1657
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

14.5.1
Figure 14.14 shows a sample flowchart for multiprocessor serial data transmission. For an ID
transmission cycle, set the MPBT bit in SSR to 1 before transmission. For a data transmission
cycle, clear the MPBT bit in SSR to 0 before transmission. All other SCI operations are the same
as those in asynchronous mode.
Multiprocessor Serial Data Transmission
Figure 14.14 Sample Multiprocessor Serial Transmission Flowchart
Clear DR to 0 and set DDR to 1
Write transmit data to TDR and
Read TDRE flag in SSR
Read TEND flag in SSR
Clear TE bit in SCR to 0
Clear TDRE flag to 0
set MPBT bit in SSR
All data transmitted?
Start transmission
Break output?
Initialization
TDRE = 1
TEND = 1
<End>
Yes
Yes
Yes
Yes
No
No
No
No
Section 14 Serial Communication Interface (SCI, IrDA, CRC)
[1]
[2]
[3]
[4]
[1] SCI initialization:
[2] SCI status check and transmit
[3] Serial transmission continuation
[4] Break output at the end of serial
The TxD pin is automatically
designated as the transmit data
output pin. After the TE bit is set
to 1, a 1 is output for one frame,
and transmission is enabled.
data write:
Read SSR and check that the
TDRE flag is set to 1, then write
transmit data to TDR. Set the
MPBT bit in SSR to 0 or 1.
Finally, clear the TDRE flag to 0.
procedure:
To continue serial transmission,
be sure to read 1 from the TDRE
flag to confirm that writing is
possible, then write data to TDR,
and then clear the TDRE flag to 0.
However, the TDRE flag is
checked and cleared
automatically when the DMAC or
DTC is initiated by a transmit
data empty interrupt (TXI)
request and writes data to TDR.
transmission:
To output a break in serial
transmission, set DDR for the
port to 1, clear DR to 0, and then
clear the TE bit in SCR to 0.
Rev.1.00 Sep. 08, 2005 Page 599 of 966
REJ09B0219-0100