DF61654N50FTV Renesas Electronics America, DF61654N50FTV Datasheet - Page 851

• Manufacturer Part Number: DF61654N50FTV
• Description: IC H8SX/1654 MCU FLASH 120TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8SX/1600r

Specifications of DF61654N50FTV

• Core Processor: H8SX
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: I²C, IrDA, SCI, SmartCard, USB
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 75
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 40K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)3DK1657 - DEV EVAL KIT FOR H8SX/1657
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

4. FKEY is cleared to H'00 for protection.
5. The download result must be confirmed by the value of the DPFR parameter. Check the value
6. The operating frequency of the CPU is set in the FPEFEQ parameter for initialization. The
 The return value is set in the DPFR parameter.
 After the on-chip program storage area is returned to the user-MAT space, the procedure
 The values of general registers of the CPU are held.
 During download, no interrupts can be accepted. However, since the interrupt requests are
 To hold a level-detection interrupt request, the interrupt must continue to be input until the
 Allocate a stack area of 128 bytes at the maximum in the on-chip RAM before setting the
 If access to the flash memory is requested by the DMAC or DTC during download, the
of the DPFR parameter (one byte of start address of the download destination specified by
FTDAR). If the value of the DPFR parameter is H'00, download has been performed normally.
If the value is not H'00, the source that caused download to fail can be investigated by the
description below.
 If the value of the DPFR parameter is the same as that before downloading, the setting of
 If the value of the DPFR parameter is different from that before downloading, check the SS
settable operating frequency of the FPEFEQ parameter ranges from 8 to 50 MHz. When the
frequency is set otherwise, an error is returned to the FPFR parameter of the initialization
program and initialization is not performed. For details on setting the frequency, see section
20.6.2 (3), Flash Program/Erase Frequency Parameter (FPEFEQ).
program is resumed. After that, VBR can be set again.
held, when the procedure program is resumed, the interrupts are requested.
download is completed.
SCO bit to 1.
operation cannot be guaranteed. Make sure that an access request by the DMAC or DTC is
not generated.
the start address of the download destination in FTDAR may be abnormal. In this case,
confirm the setting of the TDER bit in FTDAR.
bit or FK bit in the DPFR parameter to confirm the download program selection and FKEY
setting, respectively.
Section 20 Flash Memory (0.18-µm F-ZTAT Version)
Rev.1.00 Sep. 08, 2005 Page 801 of 966
REJ09B0219-0100