DF2211NP24V Renesas Technology / Hitachi Semiconductor, DF2211NP24V Datasheet - Page 397

• Manufacturer Part Number: DF2211NP24V
• Description: H8S/2200 Series, 2212 Group, USB, RTC, HSS TNP-64B; Vcc= 2.7 to 3.6 volts, Temp= -20 to 75 C; Package: PVQN0064LB-A
• Manufacturer: Renesas Technology / Hitachi Semiconductor

10.3
10.3.1
To use the WDT as a watchdog timer, set the WT/IT bit in TCSR and the TME bit to 1.
TCNT does not overflow while the system is operating normally. Software must prevent TCNT
overflows by rewriting the TCNT value (normally be writing H'00) before overflows occurs.
When the RSTE bit of the RSTCSR is set to 1, and if the TCNT overflows, an internal reset signal
for this LSI is issued. In this case, select power-on reset or manual reset* by setting the RSTS bit
of the RSTCSR to 0.
If a reset caused by a signal input to the RES pin occurs at the same time as a reset caused by a
WDT overflow, the RES pin reset has priority and the WOVF bit in RSTCSR is cleared to 0. The
internal reset signal is output for 518 states.
When the TCNT overflows in watchdog timer mode, the WOVF bit of the RSTCSR is set to 1. If
the RSTE bit of the RSTCSR has been set to 1, an internal reset signal for the entire LSI is
generated at TCNT overflow.
Note: * Supported only by the H8S/2218 Group.
Operation
Watchdog Timer Mode
Internal reset signal*
Legend:
WT/IT:
TME:
Note: * With WDT0, the internal reset signal is generated only when the RSTE bit is set to 1.
H'FF
H'00
Timer mode select bit
Timer enabl bit
TCNT value
Figure 10.2 Operation in Watchdog Timer Mode
WT/IT = 1
TME = 1
H'00 written
to TCNT
Internal reset
generated
518 states (WDT0)
Overflow
WOVF = 1
Rev.7.00 Dec. 24, 2008 Page 343 of 698
WT/IT = 1
TME = 1
H'00 written
to TCNT
REJ09B0074-0700
Time