R0K572030S000BE Renesas Electronics America, R0K572030S000BE Datasheet - Page 1025

• Manufacturer Part Number: R0K572030S000BE
• Description: KIT DEV FOR SH7203
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K572030S000BE

• Contents: CPU Board, LCD Module, E10A-Lite Emulator, Cable, QuickStart Guide and CD-ROM
• Silicon Manufacturer: Renesas
• Kit Contents: Board
• Silicon Family Name: SH7203
• Silicon Core Number: R5S72030W200FP
• Tool / Board Applications: General Purpose MCU, MPU, DSP, DSC
• Mcu Supported Families: SH7203
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: SH7203
• Lead Free Status / Rohs Status: Compliant

Figure 19.15 shows allowed state transitions.
Notes: 1. MCR5 can be cleared by automatically by detecting a dominant bit on the CAN Bus if
The following table shows conditions to access registers.
⎯ Please don't set MCR5 (Sleep Mode) without entering Halt Mode.
⎯ After MCR1 is set, please don't clear it before GSR4 is set and RCAN-TL1 enters Halt
Mode.
2. MCR1 is cleared in SW. Clearing MCR1 and setting MCR5 have to be carried out by
3. MCR1 must not be cleared in SW, before GSR4 is set. MCR1 can be set automatically
4. When MCR5 is cleared and MCR1 is set at the same time, RCAN-TL1 moves to Halt
MCR7 is set or by writing ‘0’.
the same instruction.
in HW when RCAN-TL1 moves to Bus Off and MCR14 and MCR6 are both set.
Request. Right after that, it moves to Halt Mode with no reception/transmission.
clear MCR1
and MCR5
except Transmitter/Receiver/BusOff, if MCR6 = 0
BusOff or except Transmitter/Receiver, if MCR6 = 1
set MCR1*
Halt Request
Halt Mode
Figure 19.15 Halt Mode/Sleep Mode
3
Transmission
clear MCR1*
Reception
set MCR5
Reset
Power On/SW Reset
clear MCR0
and GSR3 = 0
Section 19 Controller Area Network (RCAN-TL1)
2
clear MCR5
set MCR1*
Rev. 3.00 Sep. 28, 2009 Page 993 of 1650
clear MCR5*
Sleep Mode
4
1
REJ09B0313-0300