R0K572030S000BE Renesas Electronics America, R0K572030S000BE Datasheet - Page 1189

• Manufacturer Part Number: R0K572030S000BE
• Description: KIT DEV FOR SH7203
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K572030S000BE

• Contents: CPU Board, LCD Module, E10A-Lite Emulator, Cable, QuickStart Guide and CD-ROM
• Silicon Manufacturer: Renesas
• Kit Contents: Board
• Silicon Family Name: SH7203
• Silicon Core Number: R5S72030W200FP
• Tool / Board Applications: General Purpose MCU, MPU, DSP, DSC
• Mcu Supported Families: SH7203
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: SH7203
• Lead Free Status / Rohs Status: Compliant

Notes: 1. This bit is valid only when 0 is read.
Bit
6
5 to 3
2
1, 0
2. This bit is valid only when 1 is written to.
3. The SQCLR SQSET bits should not be set to 1 at the same time. Before operating
4. To change the SQSET or SQCLR bit in this register and that in PIPEnCTR in
Bit Name
SQMON
⎯
CCPL
PID[1:0]
either bit, PID = NAK should be set.
succession (to change the PID sequence toggle bits of multiple pipes in succession), an
access cycle of at least 120 ns and 5 or more bus clock cycles is required.
Initial
Value
1
All 0
0
00
R/W
R
R
R/W
R/W
Description
Toggle Bit Confirmation
0: DATA0
1: DATA1
When the function controller function is selected,
this module initializes this bit to 1 immediately after
the SETUP token of the control transfer has been
received.
Reserved
These bits are always read as 0. The write value
should always be 0.
Control Transfer End Enable
0: Invalid
1: The control transfer is ended
When the function controller function is selected,
this bit is cleared to 0 immediately after the SETUP
token has been received. When the host controller
function is selected, this bit should be cleared to 0.
Response PID
00: NAK response
01: BUF response (depending on the buffer state)
10: STALL response
11: STALL response
When the function controller function is selected,
these bits are cleared to B'00 immediately after the
SETUP token has been received. If a transfer error
is detected, the controller sets these bits to end the
transfer.
Section 23 USB 2.0 Host/Function Module (USB)
Rev. 3.00 Sep. 28, 2009 Page 1157 of 1650
REJ09B0313-0300