R0K572030S000BE Renesas Electronics America, R0K572030S000BE Datasheet - Page 1215

• Manufacturer Part Number: R0K572030S000BE
• Description: KIT DEV FOR SH7203
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K572030S000BE

• Contents: CPU Board, LCD Module, E10A-Lite Emulator, Cable, QuickStart Guide and CD-ROM
• Silicon Manufacturer: Renesas
• Kit Contents: Board
• Silicon Family Name: SH7203
• Silicon Core Number: R5S72030W200FP
• Tool / Board Applications: General Purpose MCU, MPU, DSP, DSC
• Mcu Supported Families: SH7203
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: SH7203
• Lead Free Status / Rohs Status: Compliant

(3)
If a pipe is under the conditions below, this module sets the corresponding bit in BEMPSTS to 1.
In this case, this module generates a BEMP interrupt if software sets the PIPEBEMPE bit in
BEMPENB corresponding to the corresponding pipe and the BEMPE bit in INTENB0 to 1. If
software clears all the bits in BEMPSTS, this module clears the BEMP bit in INTSTS0.
1. When the transmitting direction (writing to the buffer memory) has been set
2. When the receiving direction (reading from the buffer memory) has been set
Figure 23.5 shows the timing at which a BEMP interrupt is generated when the function controller
function has been selected.
Figure 23.5 Timing at which BEMP Interrupt Is Generated when Function Controller
When all of the data stored in the buffer memory has been transmitted
If the buffer memory is being used as a double buffer, however, the following conditions
should be met.
⎯ A BEMP interrupt is generated if the buffer on one side is empty and transmitting of data
⎯ A BEMP interrupt is generated if data consisting of less than eight bytes is being written to
If the size of the data packet that was received exceeded the maximum packet size and the
maximum packet size is not set to 0 (MXPS ≠ 0), this module sets the PID bit of the
corresponding pipe to STALL.
(1) Data transmission
(2) Data reception
BEMP Interrupt
USB bus
BEMP interrupt
USB bus
BEMP interrupt
from the buffer on the other side has been completed.
the buffer on one side, and transmitting of data on the other side of the buffer has been
completed.
OUT token packet
IN token packet
Function is Selected
Data packet
Data packet
Section 23 USB 2.0 Host/Function Module (USB)
Rev. 3.00 Sep. 28, 2009 Page 1183 of 1650
STALL handshake
ACK handshake
REJ09B0313-0300